O2 Oxygen Sensor for Holden Crewman VZ  2004 - 2007 (3.6L, HFV6, V6) Lambda Probe is a small probe located on the car exhaust, between the exhaust manifold and the catalytic converter. The lambda probe, situated before the catalyses, permanently measures the quantity of oxygen present in exhaust gases to change the air-fuel mixture

Compatibility for:

• Holden Crewman VZ 08/2004 - 07/2007 3.6L V6 HFV6 LE0
• Holden Crewman VZ 08/2004 - 07/2007 CROSS 6 3.6L V6 HFV6 LE0

 

Note: DOES NOT FIT FOR LY7 ENGINES WITH 6 PIN CONNECTOR, 4 PIN CONNECTOR ONLY

 

Reference OEM: 0258006743, 92210450, 0258006378, 0258010068, COS1195, EGO-135, 55566592, 92171135

 

Features:

• Simple installation, Plug & Play fast response
• It can improve engine efficiency performance and fuel economy, reduce CO2 and other emissions
• Stable characteristics and high reliability
• Manufactured to strict engineering quality and standards
• Ensure maximum strength and durability for long-term use

 

 

Can you drive with a faulty lambda sensor?

• Yes, you can drive with a bad oxygen sensor if you can still start your engine and feel little difficulty driving. But don't leave it alone for over a couple of days, as it might cause safety problems and lead to the malfunction of other parts of your vehicle

What happens if the lambda sensor is faulty?

• A damaged lambda sensor or fault in the fuel system can result in a high air to fuel ratio, producing black soot which damages the lambda sensor. Measure exhaust gases to ensure the fuel system is functioning correctly

Why do lambda sensors fail?

• The Lambda sensor operates in extremely high temperatures, so damage to the heater element of the sensor is the most frequent fault associated with this part. Vibration or damage to connectors and/or wires can also cause failure. Another common cause of premature failure is contamination

How do you know which O2 sensor needs to be replaced?

• It is best to replace O2 sensors in pairs. For example, if you replace the downstream left sensor, you should also replace the downstream right. However, on most vehicles produced since 1996, replacing one sensor (especially the front engine monitoring sensor) will cause the ECU to set a code for the other sensors

 

Specification: 

• 4 Wire Sensor Overall Length 400mm
• Condition: New
• Material: Alloy, Plastic and Rubber
• Total Length: 38 cm
• Plastic Connector Size: 2*0.5 cm
• Metal Connector Diameter: 1.5cm

Package Included: 1x O2 Oxygen Sensor with 4 pin connector