Blower Motor Resistor for Volkswagen VW Amarok 2011 - 2017 front or rear auto temp control replacement to fix problem with heater fan only runs at the highest speed setting (4 or 5) and doesn't work at low speeds, easy to install and replace the old or stock one

 

Compatibility:

• For Volkswagen VW Amarok 2011 - 2017

 

Reference OE/OEM Number:  7L0907521B, 7L0907521A, 7L0907521, QRES7396, YL7396, 021919081D, 95557234100, 95557234101, 95557234102, JA1685

 

Features: 

• Blower Motor Resistor replace controls the speed of the blower motor and is crucial to provide air flow in your vehicle's cabin
• Innovative engineering, manufacturing technology and quality control ensure that Blower Motor Resistor meet or exceed the performance of the original equipment replace
• Every replacement Blower Motor Resistor is designed to OE fit, form and function requirements accomplished by leveraging OE expertise
• Easy to install and replace the old or stock one, direct fitment

 

Specification:

• Type: Blower Motor Resistor
• For vehicles with air conditioning front and rear
• For vehicles with 2nd evaporator
• Number of connections: 4 pin + 2 pin

 

How to replace a blower motor resistor?   

• Step 1: Locate the blower motor resistor. It can be found below the blower motor. In some vehicle’s you need to remove the glove compartment to access the blower motor resistor.   
• Step 2: Now that you’ve located the blower motor resistor, you’ll now need to disconnect the resistor from the housing and then remove the harness.   
• Step 3: After disconnecting the wiring harness, the blower motor resistor will easily slide out of the HVAC housing. Now install the new resistor. If the new resistor you’ve bought comes with a gasket, then make sure you remove the old gasket too. Also, some resistors do not have any type of gasket.   
• Step 4: With the new resistor in place, check if the blower motor is functioning properly. If you’re satisfied with the results, reattach the wiring harness and place it in its previous position.   
• Step 5: If you had removed the glove compartment to access the blower resistor, place it back again.  

 

Package includes: 1x Blower Motor Resistor